TOOL ASSEMBLY
WARNING!
To reduce the risk of injury, always unplug tool
before attaching or removing accessories. Use
only specifically recommended accessories.
Others may be hazardous.
Removing and Replacing the Quik-Lok® Cord
Select Models (Fig. 1)
.
Fig 1
1. To remove the Quik-Lok® Cord, turn the cord nut 1/4 turn
to the left and pull it out.
2. To replace the Quik-Lok® Cord, align the connector key-
ways and push the connector in as far as it will go. Turn the
cord nut 1/4 turn to the right to lock.
Selecting a Blade
Use MILWAUKEE Sawzall Blades for best performance.
When selecting a blade, choose the right type and length.
Many types of blades are available for a variety of applica-
tions: cutting metal, wood, nail-embedded wood, scroll cut-
ting, roughing-in, and contours.
Many lengths are also available. Choose a length long
enough to extend beyond the shoe and your work throughout
the stroke. Do not use blades less than 3-112" long since
they won't extend beyond the shoe throughout the stroke.
For best performance and longest life, see "Accessories" to
select the best blade for the job.
RenTrain INC
Milwaukee Tool
Super Sawzall®
Model Numbers: 6527, 6527-21, 6528, 6537-22, 6537-75
Operating Instructions
IInstalling and Removing Blades
Blade Clamp Select Models (Fig. 2)
Unplug the tool before changing blades. Be sure the spindle
and blade clamp area are clean. Metal chips and sawdust may
prevent the blade clamp screw from clamping securely.
1. Depending on the job, the blade may be inserted with the
teeth facing upward or downward.
To install a blade, loosen the blade clamp screw, turning it
counterclockwise. Insert the blade until the tang butts against
the spindle.
NOTE: The blade must be inserted all the way into the spin-
dle so that the tang on the blade seats firmly in the blade
clamp.
Insert the hex key into the blade clamp screw, turning it
clockwise. Tighten securely.
2. To remove a blade, insert hex key into the blade clamp
screw and turn it counterclockwise 1 full turn as shown. Then
slide the blade out of the spindle. Be careful when handling
hot blades.
Quik-Lok° Blade Clamp - Select Models (Fig. 3)
Unplug the toot before changing blades. Be sure spindle and
blade clamp areas are clean. Metal chips and sawdust may
prevent Quik-Lok® Blade Clamp from clamping securely.
Page 1
.
Fig 2
Hex Key
Blade Clamp Screw
RenTrain INC