Advertisement
WARNING!
To reduce the risk of explosion, electric shock
and property damage, always check the work
area for hidden gas pipes, electrical wires or
water pipes when making blind of plunge cuts.
1. Insert the blade into the tool.
If you inserted the blade with the teeth facing downward,
hold the tool as shown in Column A, resting the edge of the
shoe on the workpiece.
If you inserted the blade with the teeth facing upward, hold
the tool as shown in Column B, resting the edge of the shoe
on the workpiece as shown.
2. With the blade just above the workpiece, pull the trigger.
Using the edge of the shoe as a pivot, lower the blade into the
workpiece as shown.
3. As the blade starts cutting, raise the handle of the tool
slowly until the shoe rests firmly on the workplace. Then
guide the tool along your cutting line to acquire the desired
cut.
NOTE: To make plunge cutting easier, use a heavy gauge
blade and install the blade with the teeth facing upward as
shown in
Column B, Fig 6, page
RenTrain INC
Operating Instructions (continued)
3.
Page 4
RenTrain INC
Advertisement
