Table of Contents
Advertisement
9.5.
Sound Level and LED brightness (Menu 44)
You may change the Sound Level (from 0 to 3) and
as
LED Seconds Dial
Select menu
44
Blinking White: Select the sound level (from 0 to 3)
Blinking Blue: Select the
Blinking Purple: Select the
9.6.
RS232 Baud Rate (Menu 45)
The RS232 port is use mainly for interface to a PC.
By default, the baud rate is set to 38400 dbs to allow the
all the parameters.
For Timing Software, this port is normally set at 9600 bds.
Setting =
0
Setting =
1
Setting =
2
Setting =
3
Setting =
4
Flow control:
If any equipment connected to the RS232 port does not allow a flow minimum of 2400 dbs (ex.
Radio transmission), a basic flow control is available.
Once this option is activated, the HL 940 sends the first frame and waits to receive the
characters 0x06 « ACK » before sending the next one.
9.7.
AUX1 RS232 (Menu 46)
The AUX Port may be used as follows:
Setting = 0
Setting = 1
Setting = 2
Setting = 3
9.8.
AUX2 RS232 (Menu 47)
Mainly used for Display communication (HL970)
Setting = 0
This setting is today blocked at 0 and could be not change.
9.9.
Display Mode (Menu 48)
Display mode (refer to the Port AUX2
Setting = 1
Setting = 2
Setting = 3
Setting = 4
9.10. Language (Menu 49)
From this menu, you have the possibility to change the print language.
Several languages are available:
Setting = 0
English
Setting = 1
French
Setting = 2
German
Setting = 3
Italian
intensity (from 0 to 10)
2 Digit Display
/
LED Seconds Dial
2400 Bds
9600 Bds
9600 Bds with Ctrt Flow
38400 Bds
57600 Bds
Serial Printer (HL 200)
RS232 at 9600 Bds
RS232 at 9600 Bds Ctrl Flow
RS232 at 38400 Bds
HL970/980 (9600 Bds)
Time of the day
Start Light
Start SPLIT (bib and count down up to 9 min 59 sec)
Start PTB (Count down up to 59 min 59 sec)
Digit / Start Light
LED Start Light
brightness (from 0 to 10)
brightness (from 0 to 10)
HL 940 Remote Control
intensity (from 0 to 10) , as well
software to access
17
Hide quick links:
Advertisement
Table of Contents
