Start Clock Program (Menu 3); Recall A Program (Menu 30); Modify A Program (Menu 31) - TAG Heuer Start clock User Manual

8. Start Clock Program (Menu 3)

This part of the menu allows you to program the specific configuration for departure intervals, count
downs, Red, Yellow, Green, and beep sequence.
The Start Clock HL 940 can save up to 50 program banks.
Programs 1 to 9 are pre-defined by TAG Heuer Timing (is it not possible to save a different program on
those banks).
TAG Heuer Timing Standard configurations:
Bank Description
1 Alpine Ski
2 Alpine Ski OK
3 Cross Country Ski
4
Rally 2 min
5 NC
6 FITA
7
NC
8 Start on Demand
9 Pacer 5 sec
The bank selected is automatically copied into "0". You are allowed to make modifications to any
parameters to meet your requirements.
The bank "0" will be used during the race.
You may save your personal parameters to banks 10 to 49.
Warning :
If you do not save your parameters, you will lose your settings when the unit is turned OFF.
You are strongly recommended to save your parameters and keep a log book of those functions.
8.1.

Recall a program (Menu 30)

Menu selection "31" allows you to recall a program.
The setting (white blanking disc) informs you that you can select a program bank. Only non-empty
bank are available. As soon it is selected, all the parameters are coping into the bank "0", and you will
be able to modify them.
8.2.

Modify a program (Menu 31)

The ideal time is always referred by the second "0" of the Display.
The setting is shown in two ways
All settings from 0 to 59 sec: displayed on the
o
All settings greater than 1 minute: the
o
Dial shows the number of seconds
Inter. Inv Compte
R/G A
rebours
60 0 30
30 0 15
60 0 30
120 0 30
0 1 240
0 0 5
5 0 5
2 Digit Display
Zone Zone Zone
Rouge Jaune Verte
5 -10 -5
5 -10 -5
3 -3 -3
20 -5 0
0 -30 0
1 -5 0
0 -5 0
LED Dial and on the
shows number of Minute and the
Start Bip Bip
Bip ON OFF
-10 -5 0
-10 -5 0
-10 -5 0
-10 -5 0
-30 -10 0
-5 -5 0
-5 -5 0
2 Digit Display
LED
Switch
Start
60
15
60
60
60
0
15
12