Overview; Unit Mounting - Lectronix T7000 Installation Instructions Manual

Overview

Installation of a T7000 system is straight forward, consisting of mounting the unit, mounting and
routing the GPS and Satellite Radio antennas, mounting and routing the cameras and cables,
mounting the microphone and routing the cable, mounting the Tire Pressure antenna and routing
the cable and connecting the system to all wiring. If the optional iPOD dock cable is used, a
suitable place to mount the dock is required.
Mounting of the various components will vary depending on the configuration of the truck, metal
or fiberglass cab structures and what options are installed. This instruction manual gives general
guidelines that can be applied to any installation. For specific truck wiring (wire locations and
functions), consult your truck dealer, service manual, service center or manufacturer.

Unit Mounting

A mounting "bucket" is available for the Freightliner Cascadia that allows direct mounting into the
dash. To install the T7000 and mounting bucket, follow these steps:
1. Remove the dash trim panel and dash top access panel, exposing the original radio
mounting bucket.
2. Remove the original radio.
3. Remove and retain the screws holding the original radio bucket in the dash.
4. Insert the new T7000 bucket into the dash and secure with the screws from the original.
5. Insert the T7000 into the new bucket once all cables have been connected.
3