Mounting Cameras; Direct Mounted Side Cameras - Lectronix T7000 Installation Instructions Manual

Mounting Cameras

Direct Mounted Side Cameras

An exploded view of the Sony side camera is shown below. The camera consists of four parts:
base, housing, housing screw and end cap. The base attaches to the vehicle via the three
mounting screws. The housing is placed over the base, slid into the molded retainer clips and
secured with the housing screw. The end cap snaps onto the housing and can be removed as
needed.
Exploded View Of Sony Side Camera
To mount the camera, use dimensions from the drawing below to locate the mounting hole
locations on the vehicle. Alternatively, place the camera base on the mounting location and mark
the hole locations on the vehicle. Mounting screws are not provided with the camera. Select an
appropriate screw for the application and drill holes of the appropriate size in each of the
mounting hole locations that were marked. Screws used for mounting can be no larger than #10.
Camera Mounting Hole Dimensions
5