Rear Camera - Lectronix T7000 Installation Instructions Manual

Camera Mounting (cont.)

Rear Camera

The rear camera consists of the camera body, mounting bracket and mounting hardware. To
install the camera, use the following procedure.
Mark mounting hole locations. Use the dimensions from the drawing below to locate
the mounting hole locations on the vehicle. Alternatively, place the mounting bracket on
the mounting location and mark the hole locations on the vehicle.
Drill the mounting holes. Once the holes are marked, drill four 10mm holes to accept
the rubber mounting nuts. Push the rubber mounting nuts into the holes, place the
bracket and secure the bracket to the rubber mounting nuts with the four supplied hex
head bolts and washers. Torque the bolts to 5-6kg/cm which will cause the rubber nuts to
expand behind the mounting surface and hold the camera bracket securely to the vehicle.
Rear Camera Mounting Hole Dimensions
Camera Bracket Mounted
7