Preparation; Installation Instructions - ClassicFlame 34HF600GRA Instruction Manual

PREPARATION

Before beginning installation of product, make sure all parts are present. Compare parts with
package contents list and diagram above. If any part is missing or damaged, do not attempt to
assemble, install or operate the product. Contact customer service for replacement parts.
Estimated Assembly Time: 15 minutes
Tools Required for Assembly (not included): Phillips screwdriver, Drill, Hammer, Level
WARNING! Do not use this electric fireplace if any part has
been under water. Immediately call a qualified service
technician to inspect and to replace any part of the electrical
system if necessary. Keep plastic wrapping away from children.
• Open the packaging carefully and remove the foam.
• Remove and discard the plastic bag.
• Be responsible when handling the packing materials.
• Keep the original packaging for future transport and/or storage.
• Check that all accessories are removed before you discard the packing.
LOCATING YOUR ELECTRIC FIREPLACE
Your new electric fireplace may be installed virtually anywhere in your home. However, when
choosing a location ensure that the general instructions are followed. For best results, install out of direct
sunlight. Power supply service must be either completed or placed within the electric fireplace prior to
finishing to avoid reconstruction.
WARNING: Keep drapery and other furnishings
at least 3 ft. from the front and sides of the
electric fireplace.
Clearance to combustibles
Sides ..........................................................2 in.
Floor ........................................................... 2 in.
Top ..............................................................2 in.
Back ............................................................0 in.

INSTALLATION INSTRUCTIONS

1. Remove mounting bracket (A) from back of
Fireplace (B) by removing the two screws at the
top back of the unit (Fig.1).
50 mm
min.
2 in.
FLOOR
Fig. 1
6
min.
min. 50 mm
2 in.
50 mm
2 in.