General Maintenance; Tire/Wheel Replacement; Front End Alignment - MANCO 6150 Owner's Manual

A. Front Wheel Replacement
Do not disassemble the castle nuts when you
replace the front wheels. It is only necessary to
remove the 4 lug nuts to remove the wheel. (See
Figure)
Tighten the nuts securely after replacing the
wheels.
B. Rear Wheel Replacement
Do not disassemble the castle nuts when you
replace the rear wheels. It is only necessary to
remove the 4 lug nuts to remove the wheel. (See
Figure)
Tighten the nuts after replacing the wheels.
C. Front Wheel Alignment (Ref Toe Adjustment Diagram)
The front wheels should be set with a "toe-in" from 1/8" to 1/4". At the centerline of the tires, measure the
Distance A and the Distance B. For proper toe adjustment, Dimension A should be 1/8" – 1/4" greater
than Dimension B.
To make adjustments:
a. Loosen the lock nuts on both sides of Front Tie Rods.
b. Ensure the steering wheel is centered, and adjust Dimension B by equally rotating the tie rods
in or out with a 12mm wrench.
c. After adjusting to the desired length, tighten the lock nut against the rod end.
d. Recheck the dimensions for proper alignment.

GENERAL MAINTENANCE

PAGE 26
OWNER'S/OPERATOR'S MANUAL – 6150 PART NUMBER 14569