General Cleaning; General Lubrication; Chain Lubrication And Adjustment; Front And Rear Shock Adjustment - MANCO 6150 Owner's Manual

E. Cleaning Instructions
Keep your kart clean by using a clean rag and a mild detergent and water solution. Wipe off all dirt and oil
from around the controls. Wipe off any spilled fuel and oil. Keep the engine clean and clear of foreign
objects, especially those around the air intake fan and air inlet ductwork.
F. General Lubrication
Lubricate the vehicle at least every 90 days, and more often, if the kart is used daily or in unusually dusty
conditions. Lubrication of the front suspension should be performed by adding fresh axle grease, with a
grease gun, to the fittings located on each A-Arm.
G. Chain Lubrication and Adjustment
For optimum chain life, regular lubrication with a spray on chain lubricant should be performed on a regular
basis. (Ref Figure below)
A new chain will have initial stretch and therefore will require adjustment. The first chain adjustment should be
made after the first 2 hours of use. If the chain has more than ½" of slack or "flex" than it will require
adjustment. To adjust:
a. Loosen Nut (1).
b. Adjust nut (2) on the underside of the tube.
c. Re-tighten Nut (1) until the proper chain tension is achieved.
H. Adjustment of Front and Rear Shock
There are five adjustable positions on each shock.
The center notch is the default position as set by the
manufacturer (Ref Figure). Use a round nut wrench to
adjust the shock.
To INCREASE the shock stiffness, rotate the ring to the
highest (longest) setting.
To DECREASE the shock stiffness, rotate the ring to the
lowest (shortest) setting.
Shock stiffness adjustments should be made based on the
overall weight of the rider and occupant.
PAGE 24
OWNER'S/OPERATOR'S MANUAL – 6150
Shock Adjustment
PART NUMBER 14569