Shifter Adjustment; Storage Instruction - MANCO 6150 Owner's Manual

I. Shifter Adjustment
Your unit may require an occasional adjustment in the shift cables due to typical stretch found during normal
operation of the kart. To make shift adjustments refer to the following procedure:
a. Push the shift lever to the "D" position
b. Check the restriction control disc
found just behind the oil level dipstick
to ensure that it has rotated forward all
the way (looking for any slack in
control cable #1)
c. Loosen adjustment nuts #1 and #2,
pulling the housing to draw the cable
tight. Re-tighten the nuts when the
cable is properly tensioned.
d. Shift the lever to the "R" position and
check the control disc to ensure that it
has rotated full towards the rear of the
kart.
e. Loosen adjustment nuts #3 and #4, pulling the cable housing to draw the #2 control cable tight.
f. Re-tighten nuts #3 and #4 when the cable is properly tensioned.
J. Storage Instruction
If you plan to store (and not operate) your kart for a period in excess of 30 days, or at the end of each driving
season, the unit should be set up for storage as follows:
a. Drain fuel tank and carburetor by allowing the engine to run completely out of fuel.
b. Lubricate the engine cylinder by removing the air cleaner and spraying an engine fogging oil through
the carburetor.
c. Do NOT save or store gasoline over the winter. Using old gasoline, which will deteriorate from
storage, will make the engine difficult to start and affect the performance of the engine.
d. Remove the battery from the unit and apply a periodic trickle charge to maintain the battery at a
proper voltage level for the next riding season.
e. To protect the paint, plastics and upholstery, it is a good idea to keep the unit covered when not in use.
PAGE 25
OWNER'S/OPERATOR'S MANUAL – 6150 PART NUMBER 14569