OHAUS DIAL-O-GRA 310 Instruction Manual page 4

UNPACKING AND ASSEMBLY INSTRUCTIONS (C UNPACKING AND ASSEMBLY INSTRUCTIONS (C
UNPACKING AND ASSEMBLY INSTRUCTIONS (Cont UNPACKING AND ASSEMBLY INSTRUCTIONS (C UNPACKING AND ASSEMBLY INSTRUCTIONS (C
3. Remove the balance head from the
lower half of the poly-container. Invert
the balance head and nest it in the
recess of the top half of the poly-
container. See Figure 5.
4. Screw the threaded rod into the hole in
the balance until it stops.
5. Slide the column down over the
threaded rod. Hold the base and
specific gravity stand in your left hand
and slide them down over the threaded
rod. (The column, base and balance
head support bracket are keyed for
correct assembly orientation.)
6. Slip the strap over the threaded rod
into the recessed area of the base.
Tighten the nut securely with the throw
away wrench.
7. Turn the balance over. If the specific
gravity stand is not already nested in
the base, lift the round section, and it
will slide down.
8. Place the pan on the pan support and
insert the pan bow in the upper
notch of the end loop as shown in
Figure 6.
End Loop
Pan Bow
Pan
Pan Support
Wrench
Nut
Strap
Base and
Specific
Gravity Stand
Column
Threaded Rod
Figure 5.
Support Bracket
Figure 6.
4
ont ont.) .) .) .) .) ont
ont
Balance Head