Safety And Lighting Information; Power Outage - Heat & Glo ST-HVBI-AU Installation And Operation Instructions Manual

FOR YOUR SAFETY
READ BEFORE LIGHTING
WARNING:
exactly, a fi re or explosion may result causing property
damage, personal injury or loss of life.
A. This heater is equipped with an
electronic pilot ignition device
which automatically lights the
burner. Do not try to light the
burner by hand.
B. BEFORE LIGHTING, smell all
around the heater area for gas.
Be sure to smell next to the fl oor
because some gas is heavier than
air and will settle on the fl oor.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
WARNING:
DO NOT CONNECT 240 VAC
TO THE CONTROL VALVE.
Improper installation, adjustment,
alteration, service or maintenance
can cause injury or property dam-
age. Refer to the owner's information
manual provided with this heater.
This heater needs fresh air for safe
operation and must be installed so
there are provisions for adequate
combustion and ventilation air.
If not installed, operated, and main-
tained in accordance with the man-
ufacturer's instructions, this product
could expose you to substances in
fuel or fuel combustion.
Keep burner and control compart-
ment clean. See installation and
operating instructions accompany-
ing heater.

2.3 POWER OUTAGE

In the event of a power interruption during operation, either
push the OFF button on the remote control or open access door
and push the switch to OFF (as shown in Figure 38) to shut off
manually. The switch must be returned to the ON position prior
to operation once power is restored.
If you do not follow these instructions
• Do not touch any electric switch; do
not use any phone in your building.
• Immediately call your gas supplier
from a neighbor's phone. Follow the
gas supplier's instructions.
• If you cannot reach your gas
supplier, call the fi re department.
C. Do not use this heater if any part
has been under water. Immediately
call a qualifi ed service technician to
inspect the heater and to replace
any part of the control system and
any gas control which has been
under water.
CAUTION:
Hot while in operation. Do not touch.
Keep children, clothing, furniture,
gasoline and other liquids having
fl ammable vapors away.
Do not operate the heater with
panel(s) removed, cracked or bro-
ken. Replacement of the panel (s)
should be done by a licensed or
qualifi ed service person.
NOT FOR USE
WITH SOLID FUEL
For use with natural, propane and
butane gases.
Heat & Glo • ST-HVBI-AU • 2082-900 Rev. J • 10/10
LIGHTING
INSTRUCTIONS
1. This heater is equipped with an igni-
tion device which automatically lights
the burner. Do not try to light the
burner by hand.
GAS
VALVE
2. Wait fi ve (5) minutes to clear out any
gas. Then smell for gas, including
near the fl oor. If you smell gas, STOP!
Follow "B" in the Safety Information
located on the left side of this label. If
you don't smell gas, go to next step.
3. To light the burner, simultaneously
press the star
buttons on the remote control until a
short acoustic signal confi rms the start
sequence has begun.
4. If the heater will not operate, check the
batteries then follow the instructions
"To Turn Off Gas to Heater" and call
your service technician or gas sup-
plier.
TO TURN OFF
GAS TO HEATER
1. Push the 'OFF' button on remote.
2. Remove batteries from receiver.
SWITCH IS SHOWN
IN "ON" POSITION
Figure 38
and up arrow
29