ℜ Loading The Quilt Top; Oading The Quilt Back - Bradley Quilt UltraQuilter Owner's Manual

ℑ
Loading the Quilt Back
1. Match the centerpoint that you
marked on the quilt back to the
centerpoint you marked on the
canvas. Using flathead pins, pin
your quilt back to Pole 3 with right
side down, pinning every 2 inches,
as shown in Figure 3.3.
2. Using the Pole 3 ratchet knob, wind
the quilt back counterclockwise
onto Pole 3, leaving 30 inches free.
3. Pull the free end of your quilt back
under Pole 2 and pin to Pole 1, as
shown in Figure 3.4. Be sure to
match the back and canvas
centerpoints.
ℜ
Loading the Quilt Top
1. Matching the top and canvas
centerpoints, pin the quilt top to
Pole 2 with right side up, as shown
in Figure 3.5.
2. Using the Pole 2 ratchet knob, wind
the quilt top clockwise onto Pole 2,
leaving about 4 inches of the free
end unwrapped.
Figure 3.3 Quilt back pinned to Pole 3
Figure 3.4 Quilt back pinned to Poles 1
and 3
Figure 3.5 Quilt top pinned to Pole 2
7
The UltraQuilter Owner's Manual
Loading a Quilt