Setting Up The Ultraquilter; ℵ Attaching The Ratchet Assembly; Oading The Sewing Machine - Bradley Quilt UltraQuilter Owner's Manual

2. Setting Up the UltraQuilter

When you set up your UltraQuilter, place it in a
location that allows access to the front and the
back of the table. You can easily assemble the
UltraQuilter in about 5 minutes.
ℵ
Attaching the Ratchet
Assembly
1. Open out the legs of the UltraQuilter
table, making sure the legs are locked,
and place the table upright.
2. Working from the front of the table,
place the Ratchet Assembly and poles
on the table. The Ratchet Assembly
should be at the left end of the table as
shown in Figure 2.1. Pole 3 is closest to
the front of the table.
3. Attach the Left Upright to the table and
tighten the wing nut so the upright is
perpendicular to the table.
4. Attach the Ratchet Assembly to the Left
Upright and loosely attach the wing nut.
ℑ
Loading the Sewing
Machine
1. Place the Top and Bottom Carriages
onto the tracks on the right side of the
table.
2. Lift up your sewing machine and hold it
next to the right side of the table.
3. Insert Pole 1 through the neck of the
sewing machine, as shown in Figure
2.2, and then place your sewing
machine on the carriage.
Warning. Place the sewing machine at
!
the back end of the Top Carriage, as
shown in Figure 2.3.
Figure 2.1 Ratchet Assembly and Left Upright
Figure 2.2 Pole 1 in machine neck area
Figure 2.3 Machine on carriages
4
The UltraQuilter Owner's Manual
Setting Up the UltraQuilter