Chevrolet Orlando 2013 Owner's Manual page 60

3-14 Seats and Restraints
To return the seats to the sitting
position:
1. Open the liftgate.
2. Make sure the outboard safety
belts are secured in the guides
on the side trim near the liftgate.
WARNING
A seat that is not locked into
place properly can move around
in a collision or sudden stop.
People in the vehicle could be
WARNING (Continued)
injured. Be sure to lock the seat
into place properly when
installing it.
3. From the rear of the vehicle,
grasp the handle on the back of
the seatback and lift the seat up
and to the rear until it locks into
place.
With head restraints that are not
installed and adjusted properly,
there is a greater chance that
occupants will suffer a neck/
spinal injury in a crash. Do not
drive until the head restraints for
all occupants are installed and
adjusted properly.
(Continued)
WARNING
4. Return the head restraint to the
upright position by pulling the
head restraint up and to the rear
until it locks into place.
Push and pull on the head
restraint to make sure that it is
locked.
WARNING
A safety belt that is improperly
routed, not properly attached,
or twisted will not provide the
protection needed in a crash. The
(Continued)