Back-Up Lamps; License Plate Lamp - Chevrolet Orlando 2013 Owner's Manual

4. Remove the taillamp assembly
by pulling it straight back until
the two posts disengage from
the grommets.
5. Remove the bulb socket from
the taillamp assembly by turning
it counterclockwise.
6. Remove the bulb by pulling it
straight out.
7. Install a new bulb into the bulb
socket.
8. Install the bulb socket into the
taillamp assembly by turning it
clockwise.
9. Install the taillamp assembly and
tighten the two screws.
10. Close the two screw covers.

Back-Up Lamps

1. Locate the bulb assembly under
the rear fascia.
2. Remove the bulb by turning it
counterclockwise and pulling it
straight out of the assembly.
3. Disconnect the electrical
connector from the bulb.
4. Install the new bulb by turning it
clockwise into the assembly.
5. Reconnect the electrical
connector to the bulb assembly.
Vehicle Care

License Plate Lamp

To replace the license plate
lamp bulb:
1. Remove the two screws from the
license plate lamp assembly.
10-29