Skoda 2012 Citigo Owner's Manual page 132

Loosening and tightening wheel bolts
Fig. 110 Changing a wheel: Undoing the wheel bolts/installation location of
the anti-theft wheel bolt
ä
First read and observe the introductory information and safety warn-
ings on page 128.
Loosening
›
Push the wheel wrench onto the wheel bolt up to the stop
›
Grasp the end of the wrench and turn the bolt about one turn to the
left » Fig. 110 - .
Tightening
›
Push the wheel wrench onto the wheel bolt up to the stop
›
Grasp the end of the wrench and turn the bolt to the right until it is tight.
1)
Use the appropriate adapter for undoing and tightening the anti-theft wheel bolts
130
Do-it-yourself
Fig. 111
Changing a wheel: Undoing the
wheel bolts using the hexagon
socket in the screwdriver handle
.
1)
.
1)
» page 131.
The anti-theft wheel bolt must be screwed with a wheel with full wheel trim at
position » Fig. 110 -  opposite the valve
2
cannot be installed.
WARNING
Undo the wheel bolts only a little (about one turn) as long as the vehicle has
not yet been jacked up – risk of an accident!
Note
If it proves difficult to undo the bolts, carefully apply pressure to the end of the
wrench with your foot. Keep hold of the vehicle when doing so, and make sure
you keep your footing.
. Otherwise the full wheel trim
1
Ð