Remote Synchronization - Travis Industries Xtreme 6020 Owner's Manual

8

Remote Synchronization

The remote control is shipped pre-synchronized to the fireplace. If, however, the remote does not work
with the fireplace, follow the directions below to synchronize the remote to the fireplace.
NOTE: The fireplace must have power and the transmitter must have batteries to complete this process.
WARNING: Shut the gas off to the fireplace prior to conducting this process.
1 The "Learn" switch is accessed by removing a cover plate over the junction box. Inside the junction
box to the side of the rheostat you will find the "Learn" switch (see the illustration below).
2 Press the "Learn" button once. The fireplace will beep once.
3 Press the "Mode" button on the remote. The fireplace will beep five times to indicate
synchronization.
NOTE: Re-setting the Receiver Module
If the receiver module fails to synchronize with the remote or wall switch after two attempts, you should
re-set the receiver module. To do this, hold down the LEARN button for approximately 10 seconds until
the receiver beeps 3 times. This indicates the receiver has been re-set and can be synchronized using
the instructions above.
© Travis Industries
Operation
Set
Mode
Fn
4100329
Beep
Beep, Beep,
Beep, Beep,
Beep
100-01247_000