Visual Inspection; Engine Fluid Capacities; Transmission Fluid Capacities - PCM 2006 5.0L MPI Owner's Operation And Maintenance Manual

VISUAL INSPECTION

It is important for the owner/operator to visually inspect
the complete engine assembly at regular intervals. Most
often, costly repairs can be avoided if potential problems
are corrected before there is a failure.
Inspect the complete engine assembly for obvious fuel,
oil, water or exhaust leaks. Check for loose, damaged
or missing parts. Check all hose clamps for adequate
tightness. Check the electrical system for loose or dirty
connections or damaged wiring.
Model
Crankcase Oil Capacity
W / New Filter
Fresh Water Cooling
System Capacity
Model
1,2
PCM, 1:1 Ratio
1,2
PCM, 1.23:1 Ratio
Hurth (Exc. V-Drive), All Ratios
Hurth V-Drive, All Ratios
PCM Power-Plus V-Drive, All Ratios
Walters RV-36D V-Drive
1 - Capacities are dependent on installation angle. Oil capacities are approximate, and may not include capac-
ity needed for transmission cooler and oil lines. Always use the dipstick to determine the exact quantity of oil
required. Add the correct amount of oil to fi ll to the "FULL" mark on the oil level dipstick.
2 - Check the transmission fl uid level at operating temperature and immediately after shutdown of the engine.

ENGINE FLUID CAPACITIES

MP 5.0L / 5.7L
4 Quarts (3.8 L)
18 Quarts (17.03 L)

TRANSMISSION FLUID CAPACITIES

1,2
1,2
1,2
ENGINE MAINTENANCE - 11
Touch up scratches, nicks and corrosion damage to
the exterior fi nish of the engine. Spray paint may be
obtained from your local PCM Engines dealer.
Protect engine fi nish from corrosion by periodically
spraying the engine exterior fi nish with a rust
preventative oil (such as WD-40).
1
All Models
2.0 Quarts (1.9 L)
2.0 Quarts (1.9 L)
4.0 Quarts (3.79 L)
4.5 - 5.0 Quarts (4.26 - 4.73 L)
1.5 Quarts (1.42 L)
1.5 Quarts (1.42 L)
L510010-06
MP 6.0L
5 Quarts (4.75 L)1
18 Quarts (17.01 L)
Type
DEXRON III
DEXRON III
DEXRON III
DEXRON III
Mobiltrans
SHC 50 synthetic
SAE 30
53