Kärcher K 2.360 Operator's Manual page 17

Symptom
No detergent.
Garden hose
connection leaks.
Spray wand leaks. Spray wand not properly
Pump is noisy.
Water leaks from
pump (up to 10
drops per minute
is permissible).
Oil Drip.
If you encounter any additional difficul-
ties not listed, please visit our website.
USA / Canada:
www.karcher-help.com
México:
www.karcher.com.mx
Cause
Detergent is too thick.
Filter on detergent suction
tube is clogged.
Damaged or clogged
detergent suction tube.
Spray wand is in high
pressure position.
Discharge nozzle is
obstructed.
Loose fittings.
Missing/worn rubber washer. Insert new washer.
attached.
Broken o-ring or plastic insert. Call Customer Support
Pump is sucking air.
Loose fittings.
Water seals are damaged or
worn.
Oil seals are damaged or
worn.
Solution
Dilute detergent, for best re-
sults use Kärcher
Run warm water through filter
to remove debris.
Remove obstruction or replace
detergent suction tube.
Turn spray wand tip to low
pressure position.
Blow out or remove debris with
fine needle.
Tighten fittings.
Insert the spray wand into the
trigger gun. Carefully press in
against the spring tension and
twist into the locked position.
Check that hoses and fittings
are air tight. Turn off machine
and purge pump by squeezing
trigger gun until a steady flow of
water emerges through the
nozzle.
Check that all fittings are tight.
Call Customer Support
Call Customer Support
detergent.
®
English 17