Display - Pioneer VSX-D510 Service Manual

Display

1
SIGNAL SELECT
DIGITAL DTS
ANALOG DIGITAL
1 SIGNAL SELECT indicators
Lights to indicate the type of input signal assigned for the
current component :
2 DIGITAL : Lights when a DOLBY DIGITAL signal is
played.
DTS : Lights when a source with DTS audio signals is played.
ANALOG : Lights when an analog signal is selected.
DIGITAL : Lights when a digital audio signal is selected.
2 DTS indicator
Lights when DTS mode is being used.
3 2 DIGITAL indicator
When the 2 (DOLBY)/DTS mode of the receiver is on, this
lights to indicate playback of a Dolby Digital signal. However,
2 PRO LOGIC lights during two channel playback of Dolby
Digital.
4 OVERLOAD indicator
This lights when an analog signal is too high (the SIGNAL
SELECT would have to be on ANALOG). It indicates the
sound is distorting and the input signal should be reduced.
5 ATT indicator
Lights when ATT is used to attenuate (reduce) the level of the
input signal (can only be used in ANALOG mode).
6 DIRECT indicator
Lights when source DIRECT is in use. This function bypasses
all tone, balance, DSP and Dolby Surround effects.
7 SPEAKER indicator
Shows if the speaker system is on or not. SP 3A means
speakers are switched on. SP 3 means speakers are switched
off.
8 MONITOR indicator
Lights when is selected. Used to hear a recording as
MONITOR
it's being made .
9 RF ATT indicator
Lights when the is on .
RF ATT
0 EON indicator
The box around EON indicator lights to inform you that the
currently tuned station carries the EON data service. When the
EON mode is set, the EON indicator ligh†s, but during actual
reception of an EON broadcast the
An empty box in the indicator spot means it is possible
EON
to pick up an EON broadcast but the receiver has not been set
to do so (this will only appear when RDS is switched on).
2
3
DIGITAL
PRO LOGIC
DSP
~
=
indicator will flash.
EON
4 5 6 7 8
ATT
MONITOR
DIRECT
SP
MIDNIGHT
LOUDNESS MONO
! @ #
- RDS indicator
Lights when an RDS broadcast is received.
= CHARACTER display
Shows the radio frequency or function (DVD/LD, CD, etc.)
receiver is using.
~ 2 PRO LOGIC indicator
When the 2 (DOLBY)/DTS mode of the receiver is on, this
lights to indicate playback of a two channel source.
! DSP indicator
Lights when any Advanced Theater or DSP mode is selected.
@ MIDNIGHT indicator
Lights when MIDNIGHT listening mode is in use.
# LOUDNESS indicator
Lights when the LOUDNESS is on. Use to boost the bass and
treble at low volume.
$ TUNER indicators
:
MONO
Lights when the mono mode is set using the
:
TUNED
Lights when a broadcast is being received.
:
STEREO
Lights when a stereo FM broadcast is being received in auto
stereo mode.
% MASTER VOLUME LEVEL
Shows the overall volume level. Volume level is maintained
even when the power is off.
level, and indicates the maximum level.
0dB
• Depending on the level settings you make for individual
channels, the MAX level can range between –10dB and
0dB.
VSX-D510
9 0 -
RF ATT EON
A TUNED
STEREO RDS
dB
$ %
button.
MPX
indicates the minimum
---dB
57