Table of Contents
Advertisement
Quick Links
®
High Performance
Indoor/Outdoor Color CCTV
Dome Camera User Manual
Products: BLK-CCD203VS, BLK-CCD205VH, BLK-CPD206VH,
BLK-CCD223VS, BLK-CCD225VH, BLK-CPD226VH
Please read this manual before using your camera, and always follow the
instructions for safety and proper use. Save this manual for future reference.
BLK-DomeCameras_CM
Advertisement
Table of Contents
Summary of Contents for SC Black Digital BLK-CCD203VS
- Page 1 High Performance Indoor/Outdoor Color CCTV Dome Camera User Manual Products: BLK-CCD203VS, BLK-CCD205VH, BLK-CPD206VH, BLK-CCD223VS, BLK-CCD225VH, BLK-CPD226VH Please read this manual before using your camera, and always follow the instructions for safety and proper use. Save this manual for future reference.
-
Page 2: Regulatory Notice
Changes or modifications not expressly approved by the manufacturer could void the user’s authority to operate the equipment. WARNING To prevent electric shock and risk of fire hazards: Use a power source that is within specification only. CAUTION Do NOT expose this appliance to rain or moisture. REGULATORY NOTICE This device complies with Part 15 of the FCC Rules. -
Page 3: Table Of Contents
Table of Contents Precautions. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .iv Introduction. -
Page 4: Precautions
Precautions Do not install the camera in extreme temperature conditions. Use the camera in environments where temperature is between 14°F and 122°F. Use adequate ventilation in high temperature. Do not install or use the camera in an environment where the humidity is high. It can cause the image quality to be poor. -
Page 5: Introduction
SECTION 1: INTRODUCTION SECTION 1 Introduction SC Black high performance indoor/outdoor CCTV dome cameras feature a very high resolution Sony ® CCD sensor providing 600 TVL, with a 2.8 – 11mm lens, a digital wide dynamic range, dual voltage range support (24 VAC, 12 VDC), and on-screen display (OSD) for control and setup. These cameras are available with or without an IR array, and in either a durable plastic or vandalproof enclosure. - Page 6 SECTION 1: INTRODUCTION Camera with vandalproof enclosure Camera with IR array and vandalproof enclosure 1.1.2 What’s in the box Your camera includes the following: Security tool • Machine screws (4) • Mounting cap • Mounting screws (4) • L-wrench • User manual • Dome bracket (optional) •...
- Page 7 SECTION 1: INTRODUCTION What’s in the box Optional dome bracket for wall and ceiling mounting 1.1.3 Tools you need To install the camera you will need: 12 VDC or 24 VAC power source • Tools for mounting the camera • High Performance CCTV Dome Camera User Manual...
-
Page 8: Cameras.with.a.plastic.enclosure
SECTION 1: INTRODUCTION 1.2 Cameras with a plastic enclosure 1.2.1 Features Wall or ceiling mounting through 3-axis camera bracket • Safety strap keeps dome cover attached while making adjustments • 1/3” Sony Super HAD CCD II: 410K pixels • High resolution 600 TV Lines •... - Page 9 SECTION 1: INTRODUCTION Camera with IR array and plastic enclosure 1.2.2 What’s in the box Your camera includes the following: Mounting screws (4) • L-wrench • User manual • Dome bracket (optional) • What’s in the box Optional dome bracket High Performance CCTV Dome Camera User Manual...
-
Page 10: Installation
SECTION 2: INSTALLATION SECTION 2 Installation 2.1 General Guidelines Outdoor installations: Use the rubber rings included with the machine screws (4) to ensure that • the unit is sealed properly. Dome/window care: Handle the dome carefully to prevent scratching. If a scratch appears over •... -
Page 11: Vandalproof.camera.mounting
SECTION 2: INSTALLATION Video Coax Power Connector Connector 2.1.1 What you need To install the camera you will need: 12 VDC or 24 VAC power source • Tools for mounting the camera • 2.2 Vandalproof camera mounting The camera can be installed on a junction box or directly to a wall or ceiling. -
Page 12: Plastic.camera.mounting
SECTION 2: INSTALLATION 2.3 Plastic camera mounting Connect the dome base to the mounting surface using four (4) screws. Route the power and video cables to the camera location and attach them to the camera drop cable (see General guidelines above). 2.4 Camera adjustments Attach a video setup monitor to the yellow RCA (EXTRA VIDEO OUT) connector inside the camera assembly, or setup a remote monitor for viewing video from the camera. - Page 13 SECTION 2: INSTALLATION Ceiling mounting Wall mounting Adjust the image with the focus and zoom levers. Configure your camera using the software menus in the OSD. See Software Setup in the following section of this manual. Place the dome cover over the base and adjust the dome window. Tighten the captive screws that secure the cover to the base.
-
Page 14: Software.setup
SECTION 3: SOFTWARE SETUP SECTION 3 Software Setup Use the SETUP joy stick on the OSD control panel to navigate through the menu system. Press the joy stick down (toward the camera) to enter the SETUP menu or select an entry, rock the stick up or down to highlight an item in the list, and left or right display the option you want to select. -
Page 15: White.balance
SECTION 3: SOFTWARE SETUP DWDR: The DWDR feature employs intelligent light level control to compensate for strong backlight conditions. DWDR: OFF / ON DWDR OFF DWDR ON 3.3 WHITE BALANCE WHITE BAL: You can select one of the following modes: ATW1 / ATW2 / AWC g SET / MANUAL (INDOOR / OUTDOOR / MANUAL) ATW1: Automatically adjusts color according to the available lighting for temperature range: —... -
Page 16: Backlight
SECTION 3: SOFTWARE SETUP RED GAIN: Adjust R gain value 0 ~ 255 — BLUE GAIN: Adjust B gain value 0 ~ 255 — 3.4 BACKLIGHT BACKLIGHT: Select OFF / BLC / HLC BLC (Back Light Compensation) AREA SEL: Select AREA1, AREA2 —... -
Page 17: Day&Night
SECTION 3: SOFTWARE SETUP MODE: ALL DAY, NIGHT ONLY — 3.5 DAY&NIGHT DAY&NIGHT: Select AUTO / COLOR / B/W / EXT · AUTO: Day&Night Auto mode D -> N LEVEL: 182 ~ 192 steps — D -> N DELAY: 1 ~ 30 SEC —... -
Page 18: Dpc.(Dead.pixel.compensation)
SECTION 3: SOFTWARE SETUP IR SMART OFF IR SMART ON R GAIN: 0 ~ 255 HEIGHT: 0 ~ 15 WIDTH: 0 ~ 15 LEFT/RIGHT: 0 ~ 15 TOP/BOTTOM: 0 ~ 15 IR LEVEL: HIGH / LOW — EXT: Day&Night EXT mode 3.6 DPC (Dead Pixel Compensation) Select DPC for dead pixel compensation processing. -
Page 19: Special
SECTION 3: SOFTWARE SETUP 3.7 SPECIAL CAM TITLE: Select camera title menu (Text edit). MOTION: Select camera title menu (Text edit) AREA SEL: Select AREA1, AREA2, AREA3, AREA4 — AREA STATE: Select OFF / ON — HEIGHT: Select 0 ~ 15 steps —... - Page 20 SECTION 3: SOFTWARE SETUP WIDTH: Select 0 ~ 255 steps — LEFT/RIGHT: Select 0 ~ 255 steps — TOP/BOTTOM: Select 0 ~ 255 steps — COLOR: Select 0 ~ 15 steps — PARK.LINE: You can insert a line on the screen. This feature may be useful when aligning the camera image with objects in the field of view.
- Page 21 SECTION 3: SOFTWARE SETUP MIRROR OFF MIRROR ON FONT COLOR: — FONT: 16 colors (O ~ 15 steps) ID & TITLE: O ~ 15 steps CONTRAST: You can adjust contrast on screen. (0 ~ 255 steps) — SHARPNESS: You can adjust camera image for clarity. (0 ~ 31 steps) —...
- Page 22 SECTION 3: SOFTWARE SETUP CAM ID: Select the camera ID. 1 ~ 255 — BAUD RATE: Select serial communication speed: 2400 / 4800 / 9600 / 19200 / 38400 / — 57600 bps PROTOCOL: Select operating protocol. PELCO-D / PELCO-P —...
-
Page 23: Specifications
SECTION 4: SPECIFICATIONS SECTION 4 Specifications Table 1. Model Differences Indoor Outdoor BLK-CCD203VS BLK-CCD223VS BLK-CCD205VH BLK-CCD225VH √ BLK-CPD206VH BLK-CPD226VH √ √ TDN: True Day & Night, uses an IR cut filter instead of switching the image to black and white. - Page 24 SECTION 4: SPECIFICATIONS Component Value Day&Night Auto / Color / BW / Ext Auto Level / Delay selectable Burst off/on / IR Smart off/on (Gain/level selectable) Dead Pixels Compensation Special Title / MD / PM / Parking / Image / Comm / Language / Version Cam Title Text edit Motion...
-
Page 25: Appendix A Troubleshooting
APPENDIX A: TROUBLESHOOTING APPENDIX A Troubleshooting Problem Solution Nothing appears on the screen. - Check the power connections. - Check the video cable connections. - Ensure that the lens mode is set to DC (VIDEO). The video image is not clear. - Clean the lens with a soft, clean cloth. -
Page 26: Camera.dimensions
APPENDIX B: CAMERA DIMENSIONS APPENDIX B Camera Dimensions All dimensions shown below are in millimeters. Camera with vandalproof housing 2.95" Camera with plastic housing 3.29" www.sc-black.com...