Remote Start Ready - Pontiac 2009 Montana SV6 Owner's Manual

After entering the vehicle during a remote start, insert
and turn the key to ON/RUN to drive the vehicle.
To manually shut off the engine after a remote start,
do any of the following:
•
Aim the RKE transmitter at the vehicle and press
the remote start button until the parking lamps
turn off.
•
Turn on the hazard warning flashers.
•
Insert the vehicle's key into the ignition switch and
turn the switch to ON/RUN and then back to
LOCK/OFF.
The remote vehicle start feature will not operate if:
•
The remote start system is disabled. See "REMOTE
START" under DIC Vehicle Personalization (Uplevel
Only) on page 3-68.
•
The vehicle's key is in the ignition.
•
The vehicle's hood, liftgate or doors are not closed.
•
The hazard warning flashers are on.
•
There is an emission control system malfunction.
•
The engine coolant temperature is too high.
•
The oil pressure is low.
•
Two remote vehicle starts have already been
provided. The maximum number of remote starts or
remote start attempts between ignition cycles
with the key is two.

Remote Start Ready

If your vehicle does not have the remote vehicle start
feature, it may have the remote start ready feature. This
feature allows your dealer/retailer to add the
manufacturer's remote vehicle start feature.
See your dealer/retailer if you would like to add the
manufacturer's remote vehicle start feature to your
vehicle.
2-9