Troubleshooting - Campa ConvectAir Installation & Operating Instructions Manual

8

TROUBLESHOOTING

PROBLEM
The heater Check that the display screen
does not heat and green light are ON.
The screen is ON, but the
heating indicator light is OFF.
The heating indicator light is still
OFF.
The «Open Window» icon and
the green light are flashing.
The heater
heats
continuously
The heater
does not
respond
to the
Programmer
The heater
The symbol
is ON but
screen when a key is touched.
still does not
respond to
commands
IN ALL OTHER CASES, CONTACT YOUR ELECTRICIAN OR THE CLOSEST AUTHORIZED CONVECTAIR SERVICE CENTER
OR CALL THE CONVECTAIR HELP LINE AT 1 800 463-6478.
Page 16
CHECK
 Check that the thermostat
is not set too high.
 Is the heater affected by
a cold draft (open door
or window, outside air
infiltration).
 Check that the
Programmer operates
properly.
 Refer to the Programmer
instruction manual.
appears on the
ACTION
Press the ON/Standby key
 Set the thermostat.
 If the room temperature is
already high enough, the
heater will not heat.
 The heater has been set to ECO
or Frost Protection mode by a
Programmer system : set the
Programmer to COMFORT.
 Check the home circuit
breakers.
 Check that the heater is not
covered or blocked, causing the
overheat control to trip – if so,
allow the heater to cool down
and check its operation again.
 The heater as detected an
«Open Window» condition and
stopped heating. Check doors
and windows and press the
Open Window key
 Set the thermostat.
 Eliminate the cold draft.
 Press the Mode key
the thermostat in Auto mode.
 Remove the Programmer or the
Receiver unit from its receptacle
and put it back in place.
The control panel is in locked mode.
Simultaneously press on the Window
key and the Temperature
adjustment knob
seconds to unlock the control panel.
to ON.
.
to set
, and hold for 3