Maintenance And Advice - Campa ConvectAir Installation & Operating Instructions Manual

7

MAINTENANCE AND ADVICE

To keep your CONVECTAIR unit clean, regular maintenance is suggested. To remove dust, use
a soft cloth. To remove a stain, use a damp cloth.
NEVER USE ABRASIVE OR ACETONE-BASED PRODUCTS TO CLEAN YOUR HEATER AS
THIS MAY DETERIORATE THE EPOXY FINISH.
Operation and maintenance tips
Your CONVECTAIR heater will become hot when in use. Caution is advised when
young children are present.
Do not insert small objects in the heater, this could cause an electrical short circuit, fire
or damage to the inner components.
igure
Any use or modifications not approved by CONVECTAIR may cause electrical short
ur, you
circuits, fire or injuries to the users.
In certain cases, it is possible for yellowing of the surface to occur over time. This is not
due to a manufacturing defect. This is caused by surrounding air, which may contain
nd 22°C.
smoke or dust, being heated and circulated through the heater.
and going out of
Prevention : it is suggested that surfaces be frequently cleaned especially with units
installed in locations where cigarette smoke is present or in the kitchen.
ht of 1.20 metres.
Never use this heater during construction work or other activities that gene-
rate a lot of dust.
thermometer and
Note : The first time your CONVECTAIR heater is used, a light smoke could be re-
leased. This is normal and should disappear after about 2 to 3 minutes.
ANY REPAIR ON YOUR CONVECTAIR HEATER SHOULD ONLY BE DONE BY A QUALIFIED TECHNICIAN, AND ONLY AFTER THE
HEATER HAS BEEN DISCONNECTED.
hermometer.
to +/- 2°C
Page 15