Table of Contents
Advertisement
Installing the DMS (Continued)
12
E-
DMS PCB Option Switches
1
Reset Switch (SW01) :
Resets the DMS when the DMS stops operating.
(Pressing the reset switch will delete all current data.
The switch must only be operated by the installer.)
2
DIP Switch(SW3) :
Used for setting the DI mode.
Operate only when the DI port is used.
<Factory Default Settings>
SW03
Note
Refer to the appendix (page 22~23) for how to install
the DI external signal control.
Advertisement
Table of Contents
