Power Supply Unit Installation - LG-Nortel ARIA SOHO Hardware Description And Installation Manual

ARIA SOHO Hardware Description and Installation Manual
KSU INSTALLATION
3.2.3.2 Closing the Front Cover
1. Insert the front cover into the slot on the KSU as shown in Figure 3.2.3.2.
2. Then put the front cover down on the KSU in the direction of the arrow, as shown.
3. Turn the screws clockwise to tighten and close the Cord Cover as in the Figure.
ㅡ
NOTE Prior to operation, the front cover of the ARIA SOHO must be closed and the screws tightened.

3.2.4 Power Supply Unit Installation

The Power Supply Unit (PSU) is installed in the KSU and the Expansion KSU by the manufacturer prior to shipping.
Before installation, make sure that the KSU is not plugged into an outlet. The PSU is located at the rear-most area of
the KSU and is capable of providing four kinds of power sources to the MBU and EMBU through the 7-pin connector,
CN7 (refer to the following Table).
FIGURE 3.2.3.2 CLOSING THE FRONT COVER
12
Issue 1
Aug, 2006