Overview Of The Command-Line Interface - Cisco 1538 series Installation Manual

Management Options (Cisco 1538M Hub)
Table 1-3
Changing Hub and Port Configuration Settings
Assigning or Changing Basic Hub Information on page 3-4
Changing the Port Settings on page 3-11
Managing the Hub Segments on page 3-17
Changing the Hub IP Information on page 3-21
Changing the CDP Settings on page 3-26
Changing the System Configuration on page 3-29
Changing Hub Security
Assigning or Changing the Hub Password on page 3-5
Changing the SNMP Settings on page 3-23
Monitoring Hub and Port Conditions
Using the Hub Image to Monitor the Hub on page 3-6
Checking or Resetting Port Statistics on page 3-15
Checking or Resetting Hub Statistics on page 3-19
Remote Monitoring on page 2-31

Overview of the Command-Line Interface

Using the CLI, you can access the hub software and perform the same basic system
configuration and system monitoring tasks available through the hub manager. You can also
perform privileged configuration and troubleshooting tasks available only through the CLI
and SNMP.
Procedures describing how to access the CLI are in the "Accessing the CLI" section on
page 2-29. For complete information about using the CLI, refer to the Cisco 1538 Series
Micro Hub 10/100 Command Reference.
1-10
Cisco 1538 Series Micro Hub 10/100 Installation and Configuration Guide
Configuration and Monitoring Tasks