Subaru 2007 B-9 Tribeca Technicians Reference Booklet page 58

2007 New Model Update
NOTE: SDI POWER WILL TURN ON AUTOMATICALLY WHEN THE DIAGNOSIS CABLE IS
CONNECTED TO THE VEHICLE. IF THE POWER OF THE SDI DOES NOT LIGHT, TURN
ON THE VEHICLE'S IGNITION SWITCH OR START THE ENGINE, AND THEN PRESS
THE SDI [PWR] KEY AND CHECK AGAIN TO SEE IF THE PWR LED OF THE SDI
LIGHTS.
3. Use the USB cable to connect the SDI to the PC.
4. Turn on the vehicle's ignition switch.
5. Double-click the SSMIII icon on the PC screen to start up the application.
6. On the Main Menu that appears on the display, select [Each System Check] and
then press the Enter key or left-click with the mouse.
7. On the System Selection Menu, select [Brake Control System] and then press the
Enter key or left-click with the mouse.
* Refer to STIS (Subaru Technical Infromation System)
2007 Legacy Page 58
(916)
*** New Feature
July 2006