Immobilizer Interface Programing - Subaru 2007 B-9 Tribeca Technicians Reference Booklet

2007 New Model Update

Immobilizer Interface Programing

NOTE: THE IMMOBILIZER INTERFACE WILL BE PROGRAMMED TO THE VEHICLE AS AN
IGNITION KEY. THIS WILL TAKE UP ONE OF THE 4 SLOTS AVAILABLE IN THE BIU.
THREE ADDITIONAL KEYS MAY BE PROGRAMED TO THE VEHICLE.
NOTE: ONLY ONE KEY FOB IS REGISTERED DURING THIS STEP BUT BOTH KEY FOBS WILL
OPERATE THE RES.
Starting your Vehicle
The remote control start function activates by pressing the START (key icon) button twice within 3
seconds on your remote control transmitter. The system will check certain **preconditions before
starting, and if all safety parameters are correct, the engine will start within 5 seconds. If the vehicle's
starter cranks but does not start or starts and stalls, the remote engine start system will power off
then attempt to start the vehicle an additional four times. If the remote start system shuts down 2
seconds after starting the vehicle, the vehicle has a battery problem.
WARNING: AVOID DANGER OF CARBON MONOXIDE, NEVER REMOTE START A VEHICLE IN A
CLOSED SPACE SUCH AS A CLOSED GARAGE.
Turning Your Vehicle Off
Press and hold the START (key icon) button again to turn the vehicle off. If the vehicle is left running
the remote start system will allow the vehicle to run for a total of 15 minutes
turn off.
Entering the Vehicle While it is Running via Remote Start
1. Unlock the vehicle doors using the factory keyless remote. If the vehicle's doors
are unlocked manually using the key, the vehicle's security system will trigger and
the remote start system will turn off. Inserting the ignition key into the ignition
cylinder and turning it to the ON or Run position will disarm the security system.
2. Enter the vehicle. Do not press the brake pedal.
3. Insert the key into the ignition and turn to the ON position. If the ignition key is
accidently turned to the start position, the system's "starter anti-grind" feature will
prevent the starter from re-cranking.
4. Press brake pedal. The RES disengages, the vehicle's power window features are
re-enabled and the vehicle will operate normally.
To engage the service mode, turn the ignition key to the ON or Run position, depress and hold the
brake pedal then, press and release the START (key icon) button on the remote control transmitter
three (3) times. The system will pause for one second and then flash the parking lights three (3)
times indicating the system is in service mode. When attempting to activate the remote start system
while in service mode, the parking lights will flash three (3) times and will not start.
To disengage the service mode, turn the ignition key to the On or RUN position, depress and hold
the brake pedal, then press and release the START (key icon) button on the remote control transmitter
three (3) times. The system will pause for one second and flash the parking lights one (1) time
indicating that the system has exited service mode.
* *Key in ignition or hood open, inspection mode connector connected
* Refer to STIS (Subaru Technical Infromation System)
2007 Subaru B9 Tribeca Page 40
(916)
15 minutes 15 minutes and then automatically 15 minutes
15 minutes
*** New Feature
June 2006