Subaru 2007 B-9 Tribeca Technicians Reference Booklet page 41

2007 New Model Update
IMPORTANT NOTE: WHEN TAKING YOUR VEHICLE IN FOR SERVICE, IT IS RECOMMENDED
Remote (RES) Transmitter Programming Mode
1. Open the driver's door (the driver's door must remain opened throughout the entire
process).
2. Insert the ignition key into the vehicle's ignition cylinder and turn to the ON or Run
position.
3. Locate the small black programming button behind the fuse box cover on the left
side of the driver's side lower dashboard. (Refer to page 39 for picture)
4. Press and hold the black programming button for 10-15 seconds. The horn will
honk and the parking lights will flash three times to indicate that the system has
entered transmitter programming mode.
5. Press and release the START (key icon) button on each transmitter. The horn will
honk and the parking lights will flash one time to indicate a successful transmitter
learn each time the START (key icon) button is pressed.
6. To exit transmitter programming mode, turn the ignition key to the OFF position,
remove the ignition key from the ignition cylinder and test operation of the remote
transmitter(s).
Enabling / Disabling Confirmation Horn Honks
1. Follow steps 1-4 in "Remote transmitter Programming Mode" above.
2. Pressing the vehicle's brake pedal will enable the confirmation horn honk feature.
The vehicle's horn will honk 1 time to indicate that confirmation horn honks have
been disabled and honk 2 times to indicate that confirmation horn honks have
been enabled.
3. To exit programming mode, turn the ignition key to the OFF position, remove the
ignition key from the ignition cylinder and test operation of the remote
transmitter(s).
See your owner's manual for additional information on the remote engine start system.
* Refer to STIS (Subaru Technical Infromation System)
June 2006
THAT YOU INFORM THE SERVICE PERSONNEL THAT YOUR VEHICLE
IS EQUIPPED WITH A REMOTE START SYSTEM.
(916)
*** New Feature
2007 Subaru B9 Tribeca Page 41