Charging The Battery - TTS Easi-Speak Pro User Manual

Alternatively you can press and hold the Record button during the whole of
n
the recording and release it when you have finished recording.
Press the Play button (green ring) to play your track. The Status LED will light
n
green while the track is playing.
When the track is finished, Easi-Speak Pro will return to standby and the
n
Status LED will be orange.
The Easi-Speak Pro will not store recordings of less than 2 seconds, so
n
ensure you record for longer than this.
Please note that the Easi-Speak Pro can only store a maximum of sixty two
n
tracks, regardless of the length of track.
Recording & Playback Modes
Easi-Speak Pro can record and playback files in two formats: MP3 or WAV files.
Depending on your application, you may want to use one of these formats rather
than another. For instance, most podcasting is done using MP3 files so this
would be the best format if you wanted to make podcasts. For information on
recording lengths for both formats see page 15.
Status LED
.
The Status LED provides you with a clear indication of what is happening with
your Easi-Speak Pro. Please take note of the following information so that you
can get the best results.
Flashing orange: Ready to play/record MP3 file
n
Steady orange: Ready to play/record WAV file
n
Steady green: Playing (or fully charged)
n
Flashing green: Playing paused
n
Steady red: Recording
n
Flashing red: Recording paused
n
Flashing red/green: Charging
n
Flashing orange/green: Battery low
n
Easi-Scope Pro
Pausing or Stopping a Track
Press the Play button (green ring) to play a track. The Status LED will shine
n
steady green.
Press the Play button again to pause the track at the current place. The
n
status LED will flash green.
Press the Play button again to resume playback.
n
To stop a playing track completely, press and hold the Play button for 2
n
seconds.
Fast Forward & Reverse
While a track is Playing or Paused...
n
Press and hold the Prev(ious) or Next track button on the 4-way rocker
n
switch.
The Status LED will flash green and will move within the current track at a
n
fast rate.
When the button is released, play or pause will continue at the new position
n
within the track.
The Play position will not pass beyond the start or end of the current track.
n
Moving Between Tracks
While a track is playing or paused...
n
Press the Prev(ious) or Next track button on the 4 way rocker to move to the
n
selected track.

Charging the Battery

Easi-Speak Pro is supplied with a partially charged battery and can be used
immediately without charging first. The battery can be charged by connecting to
the USB port of an active computer or the charger. No software is required:
Connect Easi-Speak Pro to the USB port or charger.
n
The Status LED will flash red and green (or orange if connected to the
n
separate charger).