Quest Engineering Promotal User Manual

Electric examination couch
Table of Contents

Advertisement

Quick Links

®
Electric Examination
Couch
2050-10/2050-20/2050-30/2050-40
2050-50
Model Shown : 2050-50

Advertisement

Table of Contents
loading

Summary of Contents for Quest Engineering Promotal

  • Page 1 ® Electric Examination Couch 2050-10/2050-20/2050-30/2050-40 2050-50 Model Shown : 2050-50...
  • Page 2 Dealer’s Phone Number : Promotal Authorized Service Company : Serial number The descriptions and features in this user’s guide are deemed correct at the time of printing. Promotal reserves the right to change or to delete these models and procedures without prior notice.
  • Page 3: Table Of Contents

    Table of Contents Important Information Safety symbols Power supply Electromagnetic interferences Installation Instructions Material delivered in cardboard packaging Fixed articles, furniture, wall furniture Dismounted material Products delivered on wooden palettes Storage condition Unpacking Authorized CE representative Instructions for Use Warning General maintenance Maintenance Instructions Painted surfaces...
  • Page 4 Accessories Headrest Installation of the headrest Pair of Clamps Installing the accessoires Arm rest Adjusting the arm rest Pair of stirrups Installing the stirrups Pair of legrests Installing the legrests 2 hook IV pole Installing the IV pole Auto-blocking I.V. pole Adjusting the height of the IV pole Installing the IV pole Pair of covers for legrests...
  • Page 5: Important Information

    Electromagnetic interferences This Promotal examination equipment was designed and built in order to minimize electroma- gnetic interferences with other devices. If interferences are noted, it is necessary to withdraw the parts causing the interference and/or to connect the equipment on isolated circuits.
  • Page 6: Installation Instructions

    Installation Instructions Material delivered in cardboard packaging Small, lightweight, easy to Heavy or cumbersome material � � handle materiel requiring the use of lifting gear In this case, the products can be easily handled In this case, it is possible to use a fork lift truck, without any lifting gear, taking care to position provided it is used correctly.
  • Page 7: Storage Condition

    Note : Authorized CE representative Countries in the EEC should direct all questions, incidents, and complaints to Promotal’s Authorized CE representative listed below : Promotal 22, Rue De St. Denis 53500 Ernee, FRANCE Phone: + 33 243 05 6895 Fax: + 33 243 05 7200 User’s Guide...
  • Page 8: Instructions For Use

    The instrument systems, control unit, adaptor etc.) be opened. must be used only for the specifi c purpose for PROMOTAL cannot be held responsible for which it is designed, and which is described in any damage resulting from the instructions not our literature.
  • Page 9: Stainless Steel Products

    Stainless steel products Cleaning and Maintenance : For maintenan- useful in getting rid of grease marks. ce of stainless steel products, periodic clea- The usual solvants (benzene, methyle- ning of the surface is suffi cient. This operation ne chloride, white spirits etc.) as well as is necessary to keep the products clean, but is domestic or specially prepared indus- facilitated by the quality of stainless steel sur-...
  • Page 10: Dimensions

    Dimensions The table is delivered dismounted The packaging contains 2 boxes : the upholstery, the paper roll holder, colour plate the frame. User’s Guide...
  • Page 11: Assembling The Couch

    Assembling the couch Unscrew the screws slightly. n°5 Allen key Unscrew the screws slightly. Tighten screws before use User’s Guide...
  • Page 12: User's Guide - Examination Couch

    User’s Guide – Examination Couch Features Electric variable height from 4cm to 2cm Steel frame with light grey epoxy finish Gas-spring assisted or electric backrest Flat upholstery with class M1 flame retardant covering Hand control Adjustable levellers under base Block’n Roll - Integrated retractable castor system ® (ref: 2050-30 and 2050-50) Paper roll holder (max length 50cm - ø 12.5) Mobile hoist compatibility –...
  • Page 13: Using The Couch

    Using the Couch Safety : For safety reasons, and in order to avoid malfunctioning, no objects should be placed under the seat cushion or between the moving parts of the couch. Connecting the hand control Possible to connect 3 controls. The hand control, located beteween the uphols- tery and the frame, may be moved or installed on the other side.
  • Page 14: Adjusting The Height

    Adjusting the height Down Press on the hand control for the desired position. Adjusting the trendelenburg position (for models 2050-20, 2050-30, 2050-40 et 2050-50) Press on the hand control for the desired position. Down User’s Guide...
  • Page 15: Adjusting The Backrest Tilt

    Adjusting the backrest tilt (for models 2050-10, 2050-20 and 2050-30) With one hand, move the lever (L1) either up or down, with the other hand lower or raise the backrest to the desired position. Caution The patient must not lean with his / her full weight on the backrest during this procedure.
  • Page 16: Adjusting The Levellers

    Adjusting the levellers Screw or unscrew the leveller (P) to the de- sired height. Paper roll Installation of the paper roll Unscrew the screws already on the upholstery. n°4 Allen key using the paper roll Insert one side of the paper roll (PR) on the support bearing, pull the other arm open by hand, and place the paper roll into position.
  • Page 17: Using The Block'n Roll

    Block’n Roll ® Using the (for models 2050-30 and 2050-50) Moving position Working position Caution Ensure the table is in a working position before placing a patient on the table. Accessories Headrest (reference 2054-01) Installing the headrest Unscrew the screws already on the upholstery. n°4 Allen key User’s Guide...
  • Page 18: Pair Of Clamps

    Pair of Clamps (reference 166) Installing the accessoires Take the stopper (B) out of the square tube if necessary. Loosen the nuts (V), and put the pair of clamps ref.1 (E) into position in the square tubes. Tighten the nuts. The clamps ac- cept accessories with a diameter of 1mm.
  • Page 19: Pair Of Stirrups

    Pair of stirrups (reference 850) Installing the stirrups Unscrew the screws (on both sides of the table) and insert the pair of stirrups. The height can be adjusted and the stirrups can pivot on the vertical axis. Tighten the screws before use. Caution Clamps are necessary to install these accessories (ref.
  • Page 20: Auto-Blocking I.v. Pole

    Auto-blocking I.V. pole Caution (reference 2985-01) Clamps are necessary to install these accessories (ref. : 166) Installing the IV pole Unscrew the screw handle. Insert the I.V. pole and rescrew. Tighten screws before use Bolt Adjusting the height of the IV pole The IV pole has 1 sliding stem.
  • Page 21: Options

    Options Using the castors Free position (reference 81036 and 2030) (for models 2050-10, 2050-20 and 2050-40) Brake position Caution Ensure brakes are fully engaged before installing a patient. (reference 81036) Using the pedal control (Reference 2051-10) (for model 2050-10) To achieve the desired movement, simply apply pres- sure on the pedal.
  • Page 22: Face Slit In Head Cushion

    Face slit in head cushion (reference 2230) Options 2230 Face slit in head cushion 103 Set of 4 double castors with brakes ø 50 2051-10 Pedal control (modèle 2050-10) 2051-20 Pedal control (modèle 2050-20 and 2050-30) 2051-30 Pedal control (modèle 2050-40 and 2050-50) User’s Guide...
  • Page 23: Lifespan

    THE CONDITION Of THE ExAmINATION COUCH SHOULD BE CHECkED AT LEAST ONCE A yEAR. Exchangeable components For all interventions, please contact your Promotal distributor, indicating the serial number on the sticker at the back of your examination couch. Obligatory/specific maintenance Once per year : •...
  • Page 24 User’s Guide...
  • Page 25: Notes

    Notes User’s Guide...
  • Page 26: Warranty Information

    No Authorization No person or fi rm is authorized to create for Promotal any other obligation or liability in connection with the products.
  • Page 27: Declaration Of Conformity

    22, rue de Saint Denis de Gastines, 53500 Ernée - FRANCE Tél. : +33 (0)2 43 05 68 95, Fax : + 33 (0)2 43 05 72 00, www.promotal.com S.A.S. au capital de 4 290 660 € - R.C.S. LAVAL Siret 421 156 720 00011 - TVA FR 67 421 156 720 - APE 331B...
  • Page 28 For more than 40 years, PROMOTAL has built its reputation on the quality of its pro- ducts. PROMOTAL offers a complete range of medical equipment from stretchers, dialysis and blood-drawing chairs to examination and gynecology tables. PROMOTAL - FRANCE www.promotal.com...

This manual is also suitable for:

2050-102050-202050-302050-402050-50

Table of Contents