Setting Details For 15-Pin D-Sub Connector Pin 15 Stop_St Status - Pioneer HD-V9000 Technical Manual

5.4. Setting Details for 15-pin D-sub Connector Pin 15 STOP_ST Status

You can use the output STOP_ST (tally signal) of Pin 15 on
the 15-pin D-sub connector to detect that video playing has
stopped, instead of using 232C Command "?P" Player Active
Mode Request or "?F" Frame Number Request.
When you use this method, you may be able to detect the
transition of Play Mode (Example: Play → Still) faster than by
using ?P or?F.
There are 2 types of STOP_ST: one is the Play status detection mode that detects the Play status and
the other is the Stop status detection mode that detects the Stop status (including Still). You can switch
between the 2 modes using the RS-232C Command. The Play status is set as the factory default mode.
Arg
0
1
(Default)
The Play status is set up as the factory default mode. The system maintains the setup values even after
the power is turned off.
The following shows the relationship between the player function mode, "?P" Command status, and
output values for this detection mode.
Status ?P Command
Standby
Stop
(No Disc)
Stop (Disc)
Play
Pause
Still
Search
Notes
This function is included in V9000 firmware Ver. 2.00 or later. Only the Stop status detection
mode is available in versions older than Ver. 2.00.
This terminal is an open collector output. It can use a maximum up to a 12 V (50mA) external
pull-up resistor.
Detection Mode
Stop status detection mode
Play status detection mode
DVD-V8000
P01 H
P01 L
P01 L
P04 H
P06 H
P05 H
P07 H
Stopped status (P01) => "L" is output.
All other statuses => "H" is output.
Play status (P04) => "L" is output.
All other statuses => "H" is output.
Ver. 1.04
H
L
H
H
H
Unspecified
11
- -
HD-V9000 Technical Manual Ver. 1.00
Function
HD-V9000
Ver. 2.00
"1SS"(Play) "0SS" (Stop)
H
H
L
H
H
Unspecified Unspecified
H
L
H
H
H