Command Line Interface - KEMP Technologies LoadMaster 1500 Installation And Configuration Manual

Farm side: eth1
IP Address
________________________________________________________________________
Netmask
________________________________________________________________________
Shared IP address
________________________________________________________________________
Hostname
________________________________________________________________________
Name Servers
(Space separated list)
________________________________________________________________________
Search Domains
(Space separated list)
________________________________________________________________________
Default Gateway
(IP Address)
III. Command Line Interface
Reference Guide
The command interface syntax is loosely based on the industry standard syntax as used by other Load
Balancer manufacturers.
The command interface has a line based, hierarchical command set. Changes made to the configuration are
only performed when returning to the top level.
Hint: A port can either be specified as a numeric value or as a symbolic name. The following names are
recognized:
DNS 53
FTP 21
HTTP 80
IMAP4 143
LDAP 389
POP2 109
POP3 110
SMTP 25
SNMP 161
SSL 443
TELNET 23
TFTP 69
1. Top level commands
At the top level the following commands may be specified.
1.1. Adaptive
This command switches the input to the adaptive parameters command set.
1.2. Delete <name|VIP>
This command will delete the specified VIP.
1.3. Disable_rs <IPspec>
Copyright © 2000 - 2005 KEMP Technologies, Inc. All Rights Reserved. 47