Backup/Restore; Remote Access Control; Basic Setup; Network Configuration - KEMP Technologies LoadMaster 1500 Installation And Configuration Manual

After a keyboard mapping has been selected, the user will be asked to check that the keyboard mapping is
correct. If the keyboard mapping is not correct the [CANCEL] button should be pressed and a different
mapping selected.

3.4. Backup/Restore

This option allows the configuration of the LoadMaster to be saved to either to a remote machine.
.
When using remote backup, the backup server machine must run an FTP daemon or an SSH daemon.
When performing a restore (from a remote machine), the user may select what information should be
restored:
Only the Virtual Service configuration
Only the information about the virtual services will be restored.
Only the LoadMaster Base Configuration
Only the LoadMaster configuration not including the virtual service configuration.
Both the Virtual Service and Base Configuration information
All the configuration information on the LoadMaster.
Important: Restoring the Virtual Service Configuration on the standby LoadMaster of a HA cluster is not
permitted since the Virtual Service configuration is always taken from the Active LoadMaster, and this would
overwrite any restored configuration.

3.5. Remote Access Control

This option allows the user to enable or disable remote access to the LoadMaster.
Enable/Disable Remote SSH access
This option allows enables or disables access to the LoadMaster via the SSH protocol. If this option is disabled,
the menus can only be accessed via the local console. If no password has been specified for "bal", it is not
possible to log in via SSH.
Enable/Disable Remote Web access
This option enables or disables access to the Web user interface.
Change Web Address
The LoadMaster is delivered with the Web user interface configured to be only accessible via the "network"
side address. With this option, the Web user interface can be configured to be accessible from only a "farm"
side address.

4. Basic Setup

This menu allows the user to perform each of the steps in the "quick setup" separately.

4.1. Network configuration

The configuration of the various IP addresses of the Ethernet interfaces can be configured.
When using the LoadMaster in a one-armed configuration, the second interface does not have to be
configured. When asked to configure the second interface (eth1) just press the [OK] button with no IP address
supplied.
If the LoadMaster is supplied with extra optional Ethernet interfaces, these interfaces can only be configured
using this menu. In this case, the on-board interfaces are no longer eth0 and eth1 but the highest numbered
Copyright © 2000 - 2005 KEMP Technologies, Inc. All Rights Reserved. 40