Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for KEMP Technologies LoadMaster
Summary of Contents for KEMP Technologies LoadMaster
- Page 1 Hardware LoadMaster Installation Guide UPDATED: 22 March 2021...
- Page 2 Copyright © 2002-2021 Kemp Technologies, Inc. All rights reserved. Kemp Technologies and the Kemp Technologies logo are registered trademarks of Kemp Technologies, Inc. Kemp Technologies, Inc. reserves all ownership rights for the LoadMaster and Kemp 360 product line including software and documentation.
-
Page 3: Table Of Contents
1.2 Intended Audience 1.3 Related Firmware Version 1.4 Prerequisites 2 Installing a Hardware LoadMaster 2.1 Connect and Power On the Equipment 2.2 Configure Networking 2.3 License and Configure the LoadMaster References Last Updated Date kemp.ax Copyright 2002-2021, Kemp Technologies, All Rights Reserved... -
Page 4: Introduction
1 Introduction 1 Introduction There is a variety of hardware LoadMaster models to choose from. For details on each please consult the Kemp website: www.kemptechnologies.com. Each of the hardware LoadMasters can be installed and licensed in the same way, as described in this document. -
Page 5: Installing A Hardware Loadmaster
For single arm setups, the switch only needs to be connected to port 0. 3. Connect a monitor and keyboard to the LoadMaster (or just a serial cable). 4. Connect the power cable to the LoadMaster. 5. Turn on power to the unit. - Page 6 Hardware LoadMaster 2 Installing a Hardware LoadMaster Once the LoadMaster is powered on, networking needs to be configured to make the LoadMaster available on your network. To do this, follow the steps below: 1. Log in to the console with the default credentials.
-
Page 7: License And Configure The Loadmaster
2.3 License and Configure the LoadMaster Follow the steps below on a computer that is connected to the same network as the LoadMaster: 1. Open a web browser. 2. In the address bar, enter https:// followed by the LoadMaster IP address, for example https://192.168.1.1. - Page 8 License field and click Apply License. For detailed instructions on how to register for a Kemp ID and license the LoadMaster, refer to the Licensing, Feature Description. 6. The Change Password screen appears kemp.ax...
- Page 9 10. If the machine has shipped with a temporary license, a warning will appear informing that a temporary license has been installed on the machine and for how long the license is valid. 11. Click OK. 12. The Appliance Vitals screen of the LoadMaster will appear. kemp.ax Copyright 2002-2021, Kemp Technologies, All Rights Reserved...
- Page 10 14. Click the eth0 menu option within the Interfaces section. 15. In the Network Interface 0 screen, enter the IP address of the eth0 interface, the network facing interface of the LoadMaster, in the Interface Address input field. 16. Click the Set Address button.
- Page 11 Address text box and click Set IPv4 Default Gateway. The LoadMaster is now fully installed and ready to be used. For further information on how to configure and implement the LoadMaster, such as steps on how to configure High Availability (HA), please refer to the LoadMaster documentation which can be accessed on here: http://kemptechnologies.com/documentation.
-
Page 12: References
Hardware LoadMaster References References Unless otherwise specified, the following documents can be found at http://kemptechnologies.com/documentation. Licensing, Feature Description kemp.ax Copyright 2002-2021, Kemp Technologies, All Rights Reserved... -
Page 13: Last Updated Date
Hardware LoadMaster Last Updated Date Last Updated Date This document was last updated on 22 March 2021. kemp.ax Copyright 2002-2021, Kemp Technologies, All Rights Reserved...
Need help?
Do you have a question about the LoadMaster and is the answer not in the manual?
Questions and answers