Table of Contents
Advertisement
INSTALLATION
The AC1037A transmission system is ready for immediate use. There are indicator LEDs
on the units for monitoring purposes. The following instructions describe the typical
installation procedure and the function of the LED indicators ( See Page 13 ).
1.
Power off the PC and AC1037A Units.
2. Connect the DVI video source (PC) to the video
input DVI-D connector on the transmitter unit.
3.
Connect a monitor to the loop-thru input of
transmitter unit if that is the monitor type
to be used on the receiver end of the link.
Ensure that the Loop/Internal EDID Switch
is in the "Loop" position.
If the loop-thru default settings are desired, ensure that the Loop/Internal EDID
Switch is in the "Internal" position. No monitor connection to the transmitter box is
required for this loop-thru position.
4.
Connect the video output(s) on the receiver unit to the DVI-D connector(s).
5.
Connect the fiber optic cable between the two AC1037A units.
6.
Connect the audio input signals to the transmitter stereo jack and the audio output to
the receiver stereo jack.
7.
Apply power to both the AC1037A units and the PC or video source. Refer to Figure 1.
8.
When power is applied, the green POWER LED will light, indicating the presence of
operating power. The VIDEO LED will give an indication as described on page 13.
9.
The green AUDIO LED will give an indication as stated on page 13.
10. The system should now be operational.
AC1037A | AC1037A-XMIT | AC1037A-REC
Advertisement
Table of Contents
