Panasonic WV-SF549 Installation Manual page 32

x
Adjust the angular field of view and the focus.
Adjust the angular field of view in accordance with the distance between the camera lens and a
photographic subject. These adjustments shall be performed together with the camera angle
adjustment.
Zoom lock knob
Loosen
q Loosen the zoom lock knob and move the knob between TELE and WIDE to obtain the appro-
priate angle of view.
w Press the auto focus (AF) button twice quickly to perform basic adjustments. The lamp blinks
during auto focus (AF) adjusting. When the adjustment is completed, adjust the viewing angle
while watching the screen.
Note:
• The focus may not be adjusted appropriately when the zoom lock knob is positioned at the "W"
(or "T") end. In this case, adjust the focus again by slightly moving the zoom lock knob to the
direction of "T" (or "W").
e To adjust the angular field of view with a higher zooming effect even after turning the zoom lock
knob almost fully in the "T" direction, adjust the zoom ratio to the "Tele" side on the [Extra opti-
cal zoom] tab on the setup menu. For information about performing the "Extra optical zoom"
setting from the setup menu, refer to the Operating Instructions (included in the CD-ROM).
r Tighten the zoom lock knob.
t After fixing the viewing angle, press the auto focus (AF) button once. The auto focus lamp lights
for about 10 seconds, and a detailed adjustment for the focus is automatically performed.
IMPORTANT:
• Do not move the focus ring by hand.
• Defocus may be caused by the reinstalled dome cover. In this case, perform the auto focus
function from the setup menu.
• Press the auto focus (AF) button twice quickly to perform basic adjustments in a short time. For
more accurate adjustments use the detailed adjustments.
• After performing basic adjustments, make sure to press the auto focus (AF) button once to per-
form detailed adjustments.
32
Auto focus (AF) button/Upside-down button
Tighten
Focus ring
* Do not move the focus ring.