Panasonic WV-SF549 Installation Manual page 26

When using 12 V DC power supply*
q Loosen the screws of the power cord plug
(accessory).
w Connect the cable of the 12 V DC power sup-
ply* to the power cord plug.
Strip 3 mm - 7 mm {1/8 inches - 9/32 inches}
from the end of the wire, and twist the stripped
part of the wire sufficiently to avoid short circuit.
Specification of cable (wire):
16 AWG - 24 AWG, Single core, twisted
• Check whether the stripped part of the wire is
not exposed and is securely connected.
e Tighten the screws of the power cord plug.
(Recommended tightening torque: 0.339 N·m
{0.25 lbf·ft})
r Connect the power cord plug to the 12 V DC
power supply terminal.
* FOR UL LISTED MODEL(S), ONLY CONNECT
12 V DC CLASS 2 POWER SUPPLY.
IMPORTANT:
• Be sure to use the power cord plug provided with this product.
• Be sure to fully insert the power cord plug (accessory) into the 12 V DC power supply terminal.
Otherwise, it may damage the camera or cause malfunction.
• When installing the camera, make sure that excessive force is not applied to the power cable.
• Be sure to use an AC adaptor compliant with the Specifications regarding power source and
power consumption. (☞ Page 43)
t Run the 12 V DC output cable through the gap of the cable hook.
26
(12 V DC)
(GND)
Power cord plug
(accessory)
12 V DC output cable
Cable hook