Fitting - Permobil Trax Service Manual

Fitting

1. When a new drive motor is to be fitted,
the magneticbrake must be moved over
from the old drive assembly. See "Fitting
the magnetic brake" on page 12.
2. Lift the motor into place on the chassis.
3. Screw the motor in place with the three
screws.
4. First attach the brake release wire to the
magnetic brake's clamp and fix the brake
cable to the mounting on the motor.
See the figure to the right.
Lift the motor in
Fit the motor
Brake release wire
21
Changing the drive motor