Repeater - EnGenius ECB7510 User Manual

9.4. Repeater

Repeater is used to extend the wireless coverage area of the Access Point. Please refer to the
previous section to configure the Access Point.
192.168.1.2
Access Point /
Wireless Router
Repeater
Step1
Step2
Step3
Step4
Step5
Note: 1. For more advanced settings, please refer to the previous chapters.
2. Repeater IP subnet must the same as the Access Point, please refer to the IP
Settings section for details.
Wireless Client
Step1
Step2
Step3
Step4
Caution: Wireless Client IP address must configure manually at the same subnet in Local Area
Network or enable DHCP server of ECB7510 to retrieve IP automatically.
Login to the web-based configuration interface with default IP
192.168.1.1
Select a Radio to change Operation Mode to Repeater from
System -> Operation Mode.
Select 802.11a/b/g/n as your wireless mode.
Use site survey to scan nearby Access Point and select the certain
AP you would like to connect with or enter SSID manually.
Select correct authentication type and password the same as
Access Point.
Open wireless client utility software page.
Use site survey to scan nearby Access Point and select the certain
AP you would like to connect with or enter SSID manually.
Configure VLAN ID in your wireless device if available.
Select correct authentication type and password.
192.168.1.1
ECB7510
192.168.1.11
Client
192.168.1.10
Client
47