Maintenance And Care; Inspection, Maintenance And Cleaning; Preheating And After-Heating Temperature - Sanoclav KL Operating Instructions Manual

2. Preheating and after-heating temperature

Preheating: If the media sensor has been activated while
the „F" key (start key) has not been de-
pressed, the autoclave is preheated to an
„operating readiness" temperature of 60°C.
After-heating: After sterilization the autoclave is cooled
down to 60°C, when the media sensor
remains activated. This temperature is
maintained until the autoclave is switched off
so that nutrient media can be further
processed.
5 Optional extras: Port for Documentation
The port for documentation of the sterilization cyclus only works
together with the MCS-processor.
It allows the transfer and documentation of sterilizationprocess
on an external PC.

6 Maintenance and Care

WARNING: It is imperative that maintenance and care
are completed according to the following table to pre-
vent damage and injury and to achieve the required
sterilization result.
6.1 Inspection, Maintenance and
Cleaning
__________________________________________________
page 29
COPYRIGHT
Firma Wolf
Labor u. pharm. Geräte
Robert Bosch Straße 13
73337 Bad Überkingen-Hausen/Germany
owns the copyright to these Operating Instructions as of
01.09.96. All rights reserved.
Wolf Labor u. pharm. Geräte does not give any guarantee for
the contents of these Operating Instructions, but particularly no
guarantee or liability for specific purposes.
No part of these Operating Instructions may be transmitted,
reproduced, revised or stored in any form, or translated into
another language. Exemptions from this prohibition can only be
given in writing by Wolf Labor u. pharm. Geräte.
Wolf Labor u. pharm. Geräte reserves the right to update and
correct the contents of these Operating Instructions at any time
without previous notification.
__________________________________________________