Operating Test Of Safety-Valve - Sanoclav KL Operating Instructions Manual

6.2 Operating Test of Safety-Valve

Table 4: Safety-Valve
turning the knurled-screw signals the functioning of the safety-
valve.
If during the test the crack is not audible, the safety-valve is
out of order.
In this case the safety-valve has to be replaced unconditional
before the next use of the sterilizer.
WARNING: A Cleaning or Repair of the safety-valve
can only be made by the manufacturer.
Any change or manipulation at the safety-valve, except the op-
erating test, can be followed by a damage of the equipment or
in case to Explosion of the pressure chamber.
⇒ DANGER TO LIFE !
__________________________________________________
page 31
Start of the Test:
•
Turn the knurled-screw
in counter- clockwise
direction
•
After an evident audi-
ble crack stop turning
of the knurled-screw
•
Now turn the knurled-
screw in clockwise-
direction back to start
position.
The audible crack while
DECLARATION OF CONFORMITY „CE"
According to the EG-directives
89/336/EWG edition of. 93/31/EWG
73/23/EWG „Low Tension"
Type and models of products
Autoclave Type : TKL – MCS – 53
Autoclave Type : TKL – MCS – 73
Autoclave Type : TKL – MCS - 122
It is declared that the above mentioned products in conception and
type of construction, also in the mode of design traded by us, meet the
above directives.
This declaration is going to loose its validity in case of changes not
agreed by us.
In accordance to following international Regulations:
DIN EN 61010 – 1 ( VDE 0411 – 1 )
DIN EN 61010 – 2 – 041 ( VDE 0411 – 2 – 041 )
pr EN 61000 – 4 – 2 pr EN 61000 – 4 - 4
EN 61000 – 4 – 11 EN 55011 or. EN 55022
In accordance to national directives/technical specifications:
pr DIN 58951 – 2 IEC 801 - 5
ADOLF WOLF SANOclav
Bad Überkingen , 07.01. 2003
Adolf Wolf .
Managing Director
„Electromagnectical Compatibility"