Towing Instructions; Towing; Towing Procedure; Releasing The Disc Brake - Linde H 50 - 02 Operator's Manual

Towing instructions

Towing

Should it become necessary to tow the truck, then it is
possible
- to by-pass the hydraulic oil circuit,
- to release the disc brakes on the wheel drives (1) with the
by-pass valve.
CAUTION
The truck cannot be braked now.
Towing the truck is only allowed with a solid connection (tow
bar). The tractor used to tow the fork truck must have sufficient
tractive and braking power for the unbraked trailer.

Towing procedure

- Lower the load so that forks do not scrape the ground
during towing.
- Deposit the load.
- Attach the tractor (be sure that tractive effort and braking
power are sufficient) with the tow bar to towing pin of lift
truck.
- Chock the wheels.
42

Releasing the disc brake

- Open bonnet, remove floor plate.
- Unscrew the cap nut (4) left of the pedal box and remove
the seal ring (3).
- Loosen locknut (2).
- Screw in the setscrew (6) as far as possible and tighten to
10 Nm.
- Lock the setscrew with the locknut (2). Tighten the locknut
to 25 Nm.
- Apply about 4 shots of grease with a grease gun through
the grease nipple (5) until the brake is released.

Opening the hydraulic by-pass valve

- Loosen the 18 or 19 mm locknut (8) under the pedal box.
- Turn the 10 mm setscrew (7) with socket out two turns.
- Lock the setscrew with locknut (8). Torque the nut to
40 Nm.
1
4
d353-02/19

After towing

- Chock the wheels at the lowest wheels.
- Loosen the locknut (8).
- Screw in the setscrew (7) (10 mm hex-socket) and torque
to 20 +5
- Lock the setscrew with the locknut (8) and tighten the nut
to 40 Nm.

Making the brakes operational again

- Loosen the locknut (2).
- Loosen the setscrew (6) two turns.
- Lock the setscrew with the locknut (2) and tighten the
locknut to 25 Nm.
- Fit the sealing ring (3).
- Screw on the cap nut (4) and tighten to 30 Nm.
Check brake function after completing re-
pairs.
2 3 4
6 5
d353-02/18
Operation
Nm.
7
8
d353-2/097