Programming your "TOWERCHRON QM2"
Setting time of day
Rotate the minute hand of the clock until the arrowhead in clock
face aligns with the correct time on the outer dial, i�e� 8 = 8�00 a�m�,
14 = 2�00 p�m�
Setting ON/OFF times
Move all tappets between ON and OFF times required to outer
position� The minimum switching time is 15 minutes�
Set any other ON/OFF periods in a similar manner
Slide switches (under drop down cover)
Pull top edge of drop down cover to gain access to slide switches�
Two switches are provided, one for heating, the other for hot water�
Depending on system installed, each switch provides following
functions:
– OFF
service off completely
– TIMED
service comes on between ON and OFF periods as set
on tappets on clock face
– CONST� service is on continuously
14
CH
ON
CH
OFF
OFF
HW
OFF
OFF
TIMED
CONST.
CH
TIMED
CONST.
CH
HW
CONST.
TIMED
HW