Page 1
Albrecht Contact Owner’s Manual Albrecht Tectalk- Contact Ø PMR 446 hand held radio Ø 8 Channels Ø 38 CTCSS Tone Codes Ø VOX Operation selectable Ø Max. 500mW RF Output Ø No License Required! Ø Clear Communication Up to 5Km Ø...
Page 2
Albrecht Contact Owner’s Manual Introduction Tectalk Contact is a palm-sized communicator that you can carry almost anywhere. Use it as well as privately radio at shopping malls, amusement parks, or sports events to contact family and friends, or in a neighborhood watch for vital communications, or also for commercial use on construction sites, for motor bike driving schools or maintenance people.
Page 3
Albrecht Contact Owner’s Manual Basic Control Power /Volume Knob Antenna Speaker Jack Microphone MONITOR Key Microphone Jack DOWN Key (Push-To-Talk) Key Speaker UP Key Display MODE / LOCK Key...
Page 4
Albrecht Contact Owner’s Manual LCD Display ¬ ® ¯ ° ± ² ¬ Battery Level Indicator Battery is fully charged Battery is half charged ¬ Battery is almost flat Blinking Cell -- Battery level Low Appears when Key Lock is ON ®...
Albrecht Contact Owner’s Manual Power ON / OFF & Volume Control At the upper right corner of the transceiver, you may find a Volume Knob. To turn On the transceiver, rotate the Volume Knob clockwise until a tick sound is heard. Rotate the knob further to increase the sound volume.
Albrecht Contact Owner’s Manual Key Tone Key Tone will be heard when keys are pressed. Power On To disable or enable it, press and hold [Monitor] when switching the radio on. Channel Selection In order to select the same operating channel as your companions, simply press UP or DOWN key at Standby Mode (“Channel”...
Albrecht Contact Owner’s Manual VOX Operation Traditionally, you should press and hold PTT key during conversation and release it after conversation so as not to occupy the channel. With the VOX operation mode, the voice transmission is started automatically once you speak at the microphone and stop after speaking.
Need help?
Do you have a question about the Contact and is the answer not in the manual?
Questions and answers