Setting Cable Box Input Channel & Brand - JVC SR-VD400U Instructions Manual

16
EN
● Turn on the VCR and the TV, and select the AV
mode on the TV.
● Set the VCR/TV/CABLE/DBS selector on the
Remote to "VCR".
VCR CABLE
TV
/DBS
2 7
Setting cable box input
channel & brand
After installation, set the cable box input channel and its
brand correctly; otherwise, the Controller cannot work
correctly.
1
2
3
4
3 – 6
INITIAL SETTINGS (cont.)
Turn on cable box
Select a channel other than channel 9 on your
cable box.
Access Main Menu screen on VCR
Press MENU.
Access Cable Set Up screen
1
Press @ # to move
the arrow to
"TUNER SET UP",
then press fi or
OK.
2
Press @ # to move
the arrow to
"CABLE SET UP",
then press fi or OK.
Select cable box input channel
Press %fi to move
the arrow to "INPUT
CH".
Your selection
depends on how your
cable box is
connected to your
VCR.
● If your cable box is connected to your VCR's
ANTENNA IN terminal on the rear panel
Press @ # until the channel number
representing the cable box's output (ON CH2 –
ON CH9) appears on the screen.
● If your cable box is connected to your VCR's
AUDIO/VIDEO IN connectors on the front panel
Press @ # until "ON F-1" appears on the
screen.
● If your cable box is connected to your VCR's
AUDIO/VIDEO IN (L-1) or AUDIO/VIDEO IN
(L-2) connectors on the rear panel
Press @ # until "ON L-1" or "ON L-2" appears
on the screen.
● If you do not use a cable box
Press @ # until "OFF" appears on the screen.
FUNCTION SET UP TUNER SET UP INITIAL SET UP
TUNER SET CABLE SET UP DBS SET UP
INPUT CH OFF
BRAND 1
TEST MODE
OK
MENU
SELECT WITH ARROW KEYS
THEN PRESS [OK]
SELECT
EXIT
FUNCTION SET UP TUNER SET UP INITIAL SET UP
CABLE SET UP
INPUT CH
OFF
BRAND 1
TEST MODE
OK
MENU
SELECT WITH ARROW KEYS
THEN PRESS [OK]
EXIT SELECT