Establishing A Cli Session - AudioCodes Media 800 MSBR User Manual

6.3

Establishing a CLI Session

The procedure below describes how to establish a CLI session with the device.
Notes:

To establish a CLI session with the device:
1. Establish a Telnet or SSH session with the device using its OAMP IP address.
2. Log in to the session using the username and password assigned to the Admin user of
the Web interface:
3. At the Username prompt, type the username, and then press Enter:
Username: Admin
4. At the Password prompt, type the password, and then press Enter:
Password: Admin
5. At the prompt, type the following, and then press Enter:
enable
6. At the prompt, type the password again, and then press Enter:
Password: Admin
Once logged in, you can configure the device by accessing one of the following modes:

Basic: Provides general CLI commands, for example, to display system information
and activate debugging. This mode is accessed immediately after you login to the CLI.
For example, to access the command shell, type the following command, and then
press Enter:
cmdshell

Enable: Provides the configuration commands and is accessed by typing the following
command:
# enable
# Password: <password>
This mode groups the commands under the following command sets:
•
configure-system: This contains the general and system related configuration
commands, for example, Syslog configuration. This set is accessed by typing the
following:
# configure system
•
configure-data: This contains the data-router configuration commands. This set
is accessed by typing the following:
# configure data
•
configure-voip: This contains VoIP-related configuration commands, for
example, SIP, VoIP network interfaces, and VoIP media configurations. This set
is accessed by typing the following:
# configure voip
User's Manual
•
The default login username and password are both "Admin" (case-
sensitive).
•
Only the primary User Account, which has Security Administration
access level (200) can access the device using Telnet. For configuring
the username and password, see Configuring Web User Accounts on
page 64.
78
Mediant 800 MSBR
Document #: LTRT-12809